Heat pumps heat and cool a home with electricity, and cold-climate models are built to keep heating in very low temperatures. NHSaves, the energy efficiency program run with New Hampshire’s utilities, notes that a contractor can help you choose the size and type of heat pump that best suits your space. These questions help you compare quotes.
Questions about the system
- How did you size it? NHSaves notes that a contractor can help you understand your home’s heating load, which narrows down the right models. Efficiency Maine, which runs the heat pump program next door, adds that bigger isn’t always better: smaller units tend to be more efficient and can often heat and cool better than oversized ones.
- Which rooms will each unit heat? Efficiency Maine’s installation guidance points out that heat rises, so a unit won’t send heat to the floor below, and that heat struggles to get through doorways into other rooms.
- Single-zone or multi-zone? Single-zone systems pair one outdoor unit with each indoor unit; Efficiency Maine lists lower operating costs, better dehumidification and backup if one unit fails among their advantages. Multi-zone systems cost less up front and need less outdoor space.
- How will it work with my existing heating? A boiler thermostat in a room heated by a heat pump may never call for heat, leaving other rooms on the same zone cold, so ask how the two systems will be controlled.
- Is my home ready? Air sealing and insulation can let a smaller system do the job. NHSaves offers energy audits for homes that qualify, which can point to weatherization work first.
Questions about the installation
- Where will the outdoor unit go? It should sit above the snow, with open airflow, away from shrubs and drifts, and not where defrost water will freeze on a walkway or roof run-off will drip onto it.
- How will it be mounted? Foundation brackets and ground stands keep noise down; wall mounts can send a low hum inside.
- Where will the line set and condensate drain run?
- Who does the electrical work, and are they licensed? New circuits are usually needed, and New Hampshire requires a licensed electrician for work at 30 volts or more.
- What warranty comes with the equipment and with the installation? Get both in writing.
Incentives
NHSaves offers incentives for heating and cooling equipment and weatherization through the participating utilities, and the amounts and rules change over time. Check its current offers, and ask each installer which incentives they’ll help you claim, before you sign.
Comparing quotes
Ask each installer for a written quote that lists the equipment model, the number and location of indoor and outdoor units, the electrical work, the warranty and any incentives. That makes quotes easier to compare side by side.